- Rapid Traverse Override F0, 50, 100%
- Feedrate override
- Linear Interpolation
- Circular Interpolation
- 2nd reference point return
- Manual Handle Feed, 1 Unit
- Manual Handle Feed Rate, X1, X10, X100
- Reader/Puncher Interface (Ch.1) interface
- Manual Absolute on/off
- Backlash Compensation
- Clock Function
- Absolute Pulse Coder Interface
- Coordinate System Setting
- Automatic Coordinate System Setting
- Decimal Point in out
- Programming Input of Offset Data
- Chamfering/Corner R
- Inch/Metric
- Tool Nose Radius Compensation Canned Cycles G70-G76
- Multiple Repetitive Cycle
- Constant Surface Speed Control G96, G97
- Spindle Speed Override
- Tool Function T1+1/T2+2
- Tool Offset Memory ¥ Tool Offset
|
- Tool Geometry/Wear Offset ¥ External Tool Offset
- Automatic Tool Offset
- Direct Input of Offset Value, measured A
- Part Program Storage Length 10m
- Registered Program 63 pieces
- Optional Block Skip 1 piece
- Background Editing
- Machine Lock All Axes/Each Axis
- Emergency Stop
- Chamfering On/Off
- Backlash Compensation for each rapid traverse and cutting feed
- Automatic Operation (Memory)
- MDI Operation
- Program Number Search
- Sequence Number Search
- Dry Run
- Single Block
- Jog Feed
- Jog and Handle Simultaneous Mode
- Threading Synchronous Cutting
- Skip Function G31
- Reference Position Return G28
- Reference Position Return Check G27
- Tangential Speed Constant Control
- Cutting Feedrate Clamp
- Automatic Acceleration/Deceleration, Rapid Traverse: Linear Cutting
Feed: Exponential
- Tape Code
- Label Skip
- Parity Check
- Control in/out
|
- Maximum Programmable Dimension, 8 digits
- Program Number 4-digits
- Sequence Number, M5-digits
- Absolute/Incremental Programming, M5-digits
- Diameter/Radius Programming (X-Axis) /X
- Plane Selection G17, G18, G19
- Sub Program Call, 4 folds nested
- Tool Offset Value Counter Input
- Part Program Editing
- Program Protect
- Status Display
- Current Program Display
- Program Display, Program name 31 characters
- Parameter Setting and Display
- Self-Diagnosis Function
- Alarm Display ¥ Alarm History Display
- Operation History Display
- Help Function
- Actual Cutting Feedrate Display
- Display of Spindle Speed and T Code at all Screens
- Servo Setting Screen
- Display of Hardware and Software configuration
- Data Protection Key
- Erase CRT Screen Display
|
